Pro Installation Guide

From VoiceRDWiki

VoiceRD Professional allows you to install and configure VoiceRD on your own VoiceRD certified harware using our installation DVD. (Check the Hardware Certification List before installing).

VoiceRD Appliance includes the VoiceRD professional pre-installed. The appliance can optionally include pre-installed integration modules. It is recommended to have a VoiceRD certified engineer to perform an installation on-site to coordinate the proper setup of the server, VoiceRD configuration, and final testing of the complete system.

Please refer to this PDF for the VoiceRD Pro installation guide.

http://voicerd.org/VRDProInstallation.pdf

The following steps walk you through installing a VoiceRD Professional version:

• Insert the VoiceRD DVD and start the server. Make sure the server is set to boot from the VoiceRD DVD.

• Select "Installation" on the SLES 10 Boot Screen.

• The VoiceRD DVD will install SLES 10 and all the required packages (You may accept all installation defaults).

• Upon boot, SLES 10 will attempt to obtain an IP address using DHCP.

• If no DHCP server is found, you will need to configure your IP manually using ifconfig or yast.
  • After the initial boot you may log in as root with password: "password", and run the command:

  ifconfig eth0 <some IP address>

Make sure the IP address is reachable from within your LAN.

Note: You can run 'yast lan' to setup the network via the YaST2 text Interface

• The server will display a URL to enter from a workstation to walk through the VoiceRD install process. Normally it is something like:

   http://<some IP address>:8181/

• Enter the URL in a web browser to initiate the VoiceRD installer and step through the install process.

Tip:One thing to look out for is to make sure that the VoiceRD LDAP tree is named differently than any existing tree.